When the circuit pressure drops due to an emergency situation, there is a possibility of reduced clamping force and the workpiece may fall. To prevent injury to personnel or damage to equipment, a fall prevention device must be installed.
2. Do not use the pneumatic fingers under the influence of excessive external force or impact.
3. For the single-action type, when it is only held by the spring force, please consult with our company.
4. When installing and fixing the pneumatic finger cylinder, be sure not to drop, collide with, or damage it.
5. When fixing the clamping爪 accessories, please do not twist the clamping爪.
6. The pneumatic fingers have the following installation methods. The tightening torque of the screws must be within the torque range specified in the table below. If it is too large, it will cause poor operation; if it is too small, it will result in position deviation and falling off.
7. Installation method for gripper accessories:
When installing the gripper accessories, be particularly careful. Only use an open-end wrench to grip the gripper, and then use an internal hexagonal wrench to tighten the screws. Do not directly grip the body and then tighten the screws; otherwise, it is easy to damage the components.
8. Ensure that no additional external force is applied to the gripper. The lateral load acts on the gripper, generating an impact load that causes the gripper to shake and get damaged. Set the clearance so that the pneumatic fingers do not collide with the workpiece and accessories at the end of the stroke.
8.1, at the end of the stroke when the pneumatic fingers are in the open position;
8.2. The pneumatic fingers move to the end of the stroke.
8.3. Reverse the action status.
When performing the reversing operation, the position where the workpiece is clamped must be accurate. Otherwise, during the reversing state, the workpiece may collide with the surrounding environment, resulting in impact loads. During the insertion action of the workpiece, the center line must be coaxial and not eccentric to avoid generating additional external forces on the mhz2-16d cylinder. In particular, during the test run, the manual operation and pressure must be reduced to operate at a low speed to ensure safety, without any impacts or other issues.
9. Please adjust the opening and closing speed of the gripper using a speed control valve or similar means to ensure it does not open or close too quickly.
10. No one is allowed to enter the movement path of the pneumatic fingers, and no items are permitted to be placed there.
11. When removing the pneumatic fingers, make sure there is no workpiece being held before releasing the compressed air and then removing the fingers.
Above is the usage method of the mhz2-16d cylinder, the installation method of the mhz2-16d cylinder content, To learn more related information, visit https://www.joosungauto.com/.
