The usage method of the MHZ2-16D Pneumatic cylinder and the installation method of the MHZ2-16D Pneumatic cylinder
1. When the circuit pressure drops due to unexpected situations, there is a possibility of reduced clamping force and the workpiece falling. To prevent injury to the human body or damage to the equipment, anti-drop devices must be installed.
2. Do not use pneumatic fingers under excessive external force or impact force.
3. For the single-acting type, if only spring force is used for clamping, please discuss with our company.
4. When installing and fixing the pneumatic finger Pneumatic cylinder, be careful not to let it drop, collide with or get damaged.
5. When fixing the gripper accessories, please do not twist the grippers.
6. There are several installation methods for pneumatic fingers. The locking torque of the fastening screws must be within the torque range specified in the table below. If it is too large, it will cause poor operation; if it is too small, it will cause positional deviation and dropping.
7. Installation method of gripper accessories:
When installing the gripper accessories, pay special attention. Only use an open-end wrench to hold the gripper and then use an Allen wrench to tighten the screws. Do not directly hold the main body and then tighten the screws, otherwise it is easy to damage the components.
8. Confirm that no additional external force is applied to the gripper. The lateral load acts on the gripper, generating an impact load effect, causing the gripper to shake and get damaged. Set a gap to prevent the pneumatic finger from colliding with the workpiece and accessories at the end of the stroke.
8.1 The end of the stroke of the pneumatic finger in the open state;
8.2 The end of the pneumatic finger's movement stroke;
8.3 Reverse action status.
When performing the reverse action, the position of the workpiece held must be accurate; otherwise, the workpiece may collide with the surrounding environment during the reverse state, generating impact loads. When the workpiece is inserted, the center lines should be coaxial and not eccentric to avoid generating additional external force on the MHZ2-16D Pneumatic cylinder. It is particularly required that during the test run, manual actions and operating pressure must be reduced, and the machine should be run at a low speed to ensure safety and no impact, etc.
9. Please adjust the opening and closing speed of the gripper with a speed control valve or the like to prevent it from being too fast.
10. People are not allowed to enter the movement path of the pneumatic finger and no items should be placed on it.
When removing the pneumatic finger, make sure it is not holding the workpiece and release the compressed air before taking it off.
Above is The usage method of MHZ2-16D Pneumatic cylinder and the installation method of MHZ2-16D Pneumatic cylinder content, To learn more related information, visit https://www.joosungauto.com/.
