1. Before using and installing the cylinder, check the condition of cylinder if any collision, and its connecting parts are tight.
2. In the process of installation, the piston rod of the cylinder can not bear the eccentric load but the transverse load, and the load direction should be the same as the axis of the piston rod.
3. No matter which installation method is adopted, it is necessary to ensure that the cylinder body does not produce deformation, and the installation base of the cylinder should have a stable stiffness, and the connection between the load and the piston rod is not allowed to be welded by electric welding.
4. Adjustment of speed: speed control valve of the opening in the middle of the adjusting range of location, then gradually adjust the output pressure of pressure reducing valve, when the cylinder is close to scheduled speed, can determine the working pressure, and then use speed control valve for fine-tuning, finally adjust the buffer of cylinder, adjust the needle valve buffer so get absorption of inertia of the piston, the ultimate speed and does not impact cylinder head is advisable.
5. When the cylinder is installed horizontally, especially the long-stroke cylinder, the level instrument is used to inspect the three-point position (the piston rod is all extended, the middle and all returned).
6. After the installation of the cylinder, it should be checked whether the cylinder works normally in the range of working pressure and under the condition of no load, and generally runs two or three times.
7. If the adjustable buffer cylinder is used, the buffer regulating valve should be adjusted to the minimum position of damping before starting to work. After the normal work of the cylinder, the buffer needle valve should be slowly adjusted to increase the buffer damping until satisfaction.
8. When using TA, TB, TC, CA, CB type cylinder installation form, it is best to regularly add lubricating oil in the installation joint part, in order to reduce the
